Mateksys F405-WING

Matek has released another Flight Controller – F405-WING. This time it is designed specially for fixed wing. It is hard to list all the features and connections of this FC. Some of the highlights: 168MHz F405 MCU, OSD, 6x hardware UARTs, 2x Motor and 7x Servo outputs, BMP280 (I2C) baro on board, PDB with current, voltage sensors, 5V, 9V and 12V BEC, also  6V or 7.2V selectable via jumper, +5V supports 6A of current.

You can connect the number of the peripherals to this FC: Receiver, ESC’s, Servos, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed…

Listed:

@ Banggood: https://www.banggood.com/Matek-Systems-F405-WING-New-STM32F405-Flight-Controller-Built-in-OSD-for-RC-Drone-p-1292190.html

@ GetFPV: https://www.getfpv.com/matek-f405-wing-flight-controller.html

FC Specifications

• MCU: 168MHz STM32F405
• IMU: MPU6000 accelerometer/gyro (SPI)
• Baro: BMP280 (I2C)
• OSD: INAV OSD w/ AT7456E chip
• Blackbox: MicroSD card slot (SD/SDHC)
• VCP & 6x UARTs
• 2x Motor, 7x Servo outputs
• 2x I2C
• 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
• Built in inverter for SBUS input (UART2-RX)
• PPM/UART Shared: UART2-RX
• SoftSerial on TX2 pad
• Battery Voltage Sensor: 1:10 (Scale 1100)
• WS2812 Led Strip : Yes
• Beeper : Yes
• RSSI: Yes

FC Firmware

• INAV Flight
• Target: MATEKF405SE

PDB

• Input voltage range: 9~30V (3~6S LiPo) w/TVS protection
• 2x ESC power pads
• Current Sensor: 104A, 3.3V ADC, Scale 317

BEC 5V output

• Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed
• Continuous current: 2 Amps, Max.3A

BEC 9V /12V output

• Designed for Video Transmitter, Camera, Gimbal ect.
• Continuous current: 2 Amps, Max.3A
• 12V option with Jumper pad

BEC Vx output

• Designed for Servos
• Voltage adjustable, 5V Default, 6V or 7.2V via jumper
• Continuous current: 5 Amps, Max.6A
• Output Ripple: 50mV (VIn=24V, VOut=5V@5A load)

BEC 3.3V output

• Designed for Baro / Compass module and Spektrum RX
• Linear Regulator
• Continuous current: 500mA

Physical

• Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
• Dimensions: 56 x 36 x 13 mm
• Weight: 25g